On this street
Exterior painting on Gordon Place
An exterior repaint on Gordon Place is a job of drawing one line correctly. Several groups on this street are brick above and stucco below: nos. 22-38 (even) are gault brick with rusticated stucco to the upper and lower ground floors, and the Orchard Street cul-de-sac houses are London stock brick laid in Flemish bond with a channelled stucco render to the ground floor. Others are stucco-fronted or stucco-finished throughout. The appraisal records that painting the brickwork above the upper ground floors of some houses has harmed the unity of the terrace, so getting the line in the right place is the whole point of this page.
Sources: Royal Borough of Kensington and Chelsea, Kensington Conservation Area Appraisal; The Volatile Organic Compounds in Paints, Varnishes and Vehicle Refinishing Products Regulations 2012, Schedule 1; HSE, Construction hazardous substances: Lead; Historic England, Listed Building Consent (Historic England Advice Note 16)
Marking the brick and stucco boundary before anything else
The survey begins with a photograph of the whole front and a line drawn on it. On nos. 22-38 (even) the rusticated stucco covers the upper and lower ground floors, with canted bay windows rising from lower ground to third floor crowned by a bottle balustrade, and gault brick everywhere else. On nos. 33-49 (odd) and nos. 46-62 (even) the channelled stucco render covers the ground floor only, with London stock brick laid in Flemish bond above it and stucco reappearing as architrave surrounds, scroll console hoods and the parapet cornice. On nos. 2-18 (even) the appraisal describes stock brick with a stucco finish, and on nos. 19-31 (odd) stock brick with a smooth stucco and painted finish, which is a different situation again.
Those are four different lines, and a quotation that does not state which one applies is not a quotation for your house. Where the stucco appears only as dressings in brickwork, the measured painted area is small but the cutting-in is long, because every architrave, hood, keystone and cornice has two edges. Where the whole front is rendered, the area is large and the modelling is concentrated in the rustication and the balustrade. The practical test is simple: if a surface is fair-faced brick today, it stays that way, and the scope says so in words.
Preparing rusticated and channelled render
Rustication and channelling are patterns made of recesses, and the single most common way to ruin them is to use filler as a skim. The working order on a previously coated front is to wash down, locate hollow and cracked areas by eye and by sounding, then remove only what is loose. Open cracks take a filler that can be tooled back until the channel or the band returns, not a bead left standing proud of the face. Vermiculated zones, bands, quoins and keystones are cut in by brush. Where a broad flat is sprayed at all, the mouldings are masked so their arrises stay sharp.
The bottle balustrade at the parapet and the canted bay are the two places to inspect hardest. A balustrade is a run of small turned or moulded elements with gaps between them, fully exposed, and it is usually the first part of a Gordon Place front to fail; a canted bay rising three or four storeys has mitred junctions at every angle, and movement shows there first. Product choice follows condition and the manufacturer's system for the background. The VOC Regulations set solvent limits by product category, including a separate category for coatings for outdoor walls of masonry, brick or stucco, which is a product-class fact and not a product recommendation.
Joinery and ironwork within the same elevation
An exterior repaint here is rarely render alone. The sash patterns change by group: six-over-six in architrave surrounds on the Orchard Street houses, two-over-two at first floor and eight-over-eight at lower ground floor on nos. 19-31 (odd), and one-over-one sashes in architrave surrounds with bracketed cornices on the stucco-fronted house at the north end. Four-panelled front doors with transom lights set within pilaster surrounds are the common entrance type, and some groups have French casements at first floor opening onto railings. Each of those is prepared as timber, with failed putty and decayed sections cut out locally and sound film left in place.
Ironwork is its own line. The appraisal records decorative cast iron railings with spiked ball finials to a lightwell at the north end, a complete run of spear-tipped railings with gates at nos. 33-49 (odd) that emphasises the unity of the group, pot guards on first-floor cills in the cul-de-sac, and front gardens enclosed with various styles of railings painted black. Metal is prepared as metal: corrosion and failed coating addressed, then a system intended for iron rather than a masonry coating stretched over it. Where railings are planted into a stone plinth or spring from a stucco dwarf wall, the junction is cut in by hand so the stone is not coated.
Lead-safe working and what gets left alone
On houses dating from the 1820s to the 1870s, older coatings may contain lead. HSE records that lead pigments were widely used in household paints until the 1960s, advises leaving sound old paint in place and stripping back only paint that is flaking, chipping or dusting, and lists dry sanding of old paint among the jobs that put people most at risk from lead dust. So the method on this street is local and low-dust: failed film taken back far enough to give the new coats a sound edge, sound film left, no blow lamp or gas torch on old paint, dust controlled at source, and debris collected rather than left in a lightwell or a front garden.
The same restraint applies to surfaces that are not paintwork at all. Fair-faced stock and gault brick is masked and left. Stone copings, plinths and front entrance steps are protected, and the appraisal's complaint about different finishes to the front entrance steps on nos. 22-38 (even) is a reminder that a step is part of the composition rather than a surface to tidy up with whatever is left in the tin. Where a textured coating is present anywhere in the work, it is not sanded or scraped through, because older textured coatings can contain asbestos; the right response is to stop and take advice rather than to improvise.
Sources: HSE, Construction hazardous substances: Lead; HSE, Old lead paint: what you need to know as a busy builder (CIS79); HSE Asbestos essentials a28, Removing textured coating from a small area
Access, consent and the drivers behind the figure
Access on Gordon Place varies sharply by group. A three-storey front with a lower ground floor, a lightwell, steps and railings planted in a plinth limits where a tower base can sit, and a canted bay rising to the third floor with a balustrade above usually means a pavement scaffold to reach the parapet properly. In the Orchard Street cul-de-sac the front doors are reached by a footpath between facing terraces with front gardens either side, so there may be no tower position at all without agreement from neighbours, and materials have to be carried rather than parked. Any licence the highway authority requires for a structure on the street is an access item priced once the position is known.
Consent is checked at the address. Ordinary repainting is maintenance under the Planning Portal's account; on a listed building Historic England treats like-for-like redecoration matching type, texture, finish and colour as usually needing no consent, painting a bare surface as likely to need it, and a change of finish as usually needing it. There is no price on this page. What moves the figure is the extent of coated render, the amount of rustication and balustrade, the number and pattern of openings, the quantity and condition of ironwork, how the parapet is reached, and what repairs are found. Ask for a quotation that names the painted surfaces, names the brick and stone excluded, and lists repairs separately.
The Gordon Place street guide, group by group from Pitt Street to Orchard Street
Exterior painting as a Kensington service, with the usual order of work
Exterior painting on Holland Street, where gauged brick heads stay bare
Edge Street, where render finishes were added to an early brick terrace
Stucco painting, if only the rusticated or channelled render is in scope
Repainting railings and basement areas, including plinths and front steps
Questions about Exterior painting on Gordon Place
How much of a Gordon Place front should be painted?
It depends on the group. Nos. 22-38 (even) are gault brick with rusticated stucco to the upper and lower ground floors only. The Orchard Street houses are Flemish-bond London stock brick with channelled stucco render to the ground floor. Others are described as stock brick with a stucco finish, or with a smooth stucco and painted finish. The survey marks that boundary on a photograph before anything is masked.
Why are the front entrance steps mentioned in the scope?
Because the appraisal treats them as part of the group's unity. It records that painting the brickwork above the upper ground floors of some houses has harmed the unity of the terrace at nos. 22-38 (even), along with different finishes to the front entrance steps. Steps are therefore protected during the work and are not given a new finish as an afterthought.
How are the railings and pot guards handled?
As metalwork, with their own preparation and system. The appraisal records spear-tipped railings with gates at nos. 33-49 (odd), decorative cast iron railings with spiked ball finials at the north end, pot guards on first-floor cills in the cul-de-sac, and front gardens enclosed with railings painted black. Corrosion and failed coating are dealt with, and junctions with stone plinths are cut in by hand.
Adjoining streets and wider work
Where the elevation needs repair beyond decoration, that wider exterior work sits with Hampstead Renovations.
If the facade itself is failing, rather than only the coating, that investigation can be discussed with Hampstead Chartered Surveyors, our sister surveying and building consultancy firm.
Start with a conversation
Tell us about your property.
Share the address, the rooms or surfaces, and what you have in mind.
Your project details
Tell us what you would like to decorate and where.